If you are setting this up, it requires a three-layer configuration to work properly: Wake up a device remotely - AnyDesk Help Center
Once configured, follow these steps to turn on your PC remotely: Open AnyDesk on your local device.
The waker must be on the same LAN. But what if you’re outside using a mobile hotspot ?
This feature often interferes with WoL. Go to Control Panel > Power Options > Choose what the power buttons do and disable Turn on fast startup .
Wake-on-LAN is an Ethernet or Token Ring computer networking standard that allows a computer to be turned on or awakened by a network message. This message is usually sent by a program executed on another computer on the same local area network (LAN).
Check and Only allow a magic packet to wake the computer . Configure AnyDesk Settings: Open AnyDesk on the computer you want to wake. Go to Settings > Wake-on-LAN . Ensure the feature is enabled.
In the tab, check "Allow this device to wake the computer" and "Only allow a magic packet to wake the computer".
To help refine this setup for your specific environment, could you tell me: What is running on the target machine?
: WoL is highly unstable over wireless networks. Use a wired Ethernet connection on the target machine for reliability.
Alex knew he had to go back home one last time to set up . Here is what he did to ensure this never happened again:
Now go ahead — let your PC sleep soundly, and wake it with a single “hot” action from anywhere on earth. Your electricity bill and your inner geek will thank you.
Here is the direct answer regarding this feature in AnyDesk: