Kes Geyser Load Control Timer Manual New 'link' [360p]

Press and M+ to set the exact time you want the geyser to begin heating.

: Requires a jumper from the Geyser Circuit Breaker output to the Controller's Live (L) input, and a Neutral (N) connection from the DB board.

Advances the hour setting (00 to 23 in 24-hour format).

Connect the Live (Red) wire from the 20A geyser circuit breaker to the L1 terminal. kes geyser load control timer manual new

For the highest efficiency, program your timer to complete its cycle roughly your peak household usage times. Standard geyser tanks take between 1.5 to 2.5 hours to heat to maximum capacity from a cold start. Recommended Daily Schedule Profile

Are you setting schedules to align with specific ?

Connects out directly to the geyser unit's Neutral line. Press and M+ to set the exact time

: Indicates the Geyser is currently "ON" and receiving power.

Choosing the right profile is a simple decision based on your lifestyle and water heating setup. Most users will benefit most from Profile 4 (Savings Program) or Profile 2 if they have a solar geyser.

Enters the scheduling menu and cycles through the 16 available On/Off slots. Connect the Live (Red) wire from the 20A

All programs include a "Lock out" period during peak times (typically 06:00–08:00 AM and 18:00–20:00 PM ) to prevent high-cost energy use. Checking the Real-Time Clock (RTC) To verify if the timer has the correct time and day: Hold the Override and Program buttons together.

Stays OFF for most of the day and night, specifically 00h00–03h00, 08h00–15h00, 20h00–24h00, and all peak times. Manual Override Feature

Press the Manual button until the indicator switches to AUTO . Verify that your current time does not fall into one of your programmed active slots.