When you search for this manual, you are likely facing one of three emergency scenarios:
The primary advantage is safety. Operators can monitor the mill from a safe location, receiving feedback from the sensors, eliminating the need for manual intervention on the mill floor.
: Provides a signal proportional to the material's position or the width/offset of a hot strip. 2. Technical Specifications Category Heat Detector / Loop Scanner Operating Voltage 20–30 VDC Detection Range 830–1000 mm Protection Rating IP66 (dust-tight and protected against heavy seas/jets) Housing Rugged aluminum case for harsh environments Weight Approximately 4.00 lbs 3. Key Operational Features
Using the diagnostic log from the ID6100 manual, implement a monthly "Hot Check" routine: id6100 danieli manual hot
The Danieli ID6100 is engineered with highly specific electrical and mechanical thresholds to handle massive thermal radiating zones. Specification Details Danieli Automation Primary Category Heat Detector / Loop Scanner / Metal Detector Operational Voltage 20–30 VDC Scanning Range / FOV 830 mm to 1000 mm Target Temperature ≥is greater than or equal to 750 °C up to active molten steel states Sensor Type Linear Charge-Coupled Device (CCD) Array Output Types
Danieli intelligent guides, often integrated with the , are not merely mechanical components. They are advanced, mechatronic devices designed to operate in the harsh environments of hot rolling mills.
This article provides a comprehensive overview of the (or technical documentation) associated with Danieli hot strip mills . It covers the general operational principles, maintenance routines, and safety guidelines typically found within technical documentation for advanced steel manufacturing equipment. When you search for this manual, you are
Uses a line CCD camera and an infrared filter to focus IR emissions onto a linear-array photo sensor. Operating Voltage: 20–30 VDC. Output Types: Activates upon material presence.
However, I can help you in the following legal and practical ways:
For complete system rebuilds, look to upgrade to active product lines like the Danieli Automation ID6000 series , which offer updated linear CCD configurations and better resistance to industrial environments. C. Finishing Mill (F-Mill)
It is part of the (process control), sitting between Level 1 (PLCs/drives) and Level 3 (MES).
Disclaimer: This article is based on publicly available information about the ID6100 and related Danieli automation products up to 2023. Always consult the specific, up-to-date manual provided by Danieli for your exact equipment version.
A3: According to multiple sources, the ID6100 has been discontinued by the manufacturer and is now considered obsolete. However, it can often be found as refurbished or reconditioned surplus stock.
Furthermore, the provides a simple on/off signal for material presence. The ID6100's ability to provide a continuous, proportional analog signal (0–10 VDC or 4–20 mA) for loop height distinguishes it as a crucial component for dynamic process control.
The roughing mill reduces the thick slab into a transfer bar. The ID6100 manual covers: Adjustments for primary reduction. Edger Control: Maintaining proper width. C. Finishing Mill (F-Mill)