: Minimum concrete base dimensions are typically deep, depending on the cabinet length.
All external inputs route directly to the main terminal board in the Master cabinet:
Gunnebo SpeedStile FL speed gates combine sleek aesthetics with reliable security. Installing these pedestrian barriers correctly ensures smooth operation, high throughput, and long-term durability.
If you want, I can generate:
The of your SpeedStile FL (e.g., FLs, FL EV, wide or standard lane)
Once the cabinets are mechanically secured and wired, attach the glass or acrylic barrier wings.
[ Master Cabinet ] [ Slave Cabinet ] +----------------+ +----------------+ | (A) (B) (C) | <<<<>> | (C) (B) (A) | +----------------+ Lane Width +----------------+ || || ======||==========================||====== Conduit Entry Step 1: Marking the Footprint gunnebo speedstile fl installation manual
The gates will perform a self-test routine. The wings will open slowly, find their mechanical limit stops, and close to establish the baseline home position. Sensor Calibration
Proper site preparation is critical for a successful installation.
The gate sounds an alarm, flashes red, and blocks the lane if safety parameters permit. : Minimum concrete base dimensions are typically deep,
Access the drive shaft by removing the internal protective guards. Align the glass wing clamp with the main drive shaft.
Connect the mains cable directly to the internal fused terminal block located near the base of the master cabinet. Ensure the grounding wire is securely bonded to the chassis earth stud. Low-Voltage Controls and Access Integration
Enter the lane from the exit side while it is open for an authorized entry. If you want, I can generate: The of your SpeedStile FL (e
A single lane requires one left and one right cabinet; multi-lane setups utilize center or "combi" cabinets. shophansab.lv Official resources like the SpeedStile FL Installation Guide Gunnebo's support portal
The installation manual provides comprehensive instructions for the physical setup, site preparation, and initial powering of these security barriers. Key procedures include aligning the units, preparing the floor with specific bolting depths, and performing a manual check before connecting electronics. Site Preparation & Foundation