Xh-m608 Manual -

Here is a practical guide to understanding and setting up your module. 1. Understanding the Hardware

[Live Voltage Screen] ──(Short Press SET)──> [P0 Menu] ──(ADD/DEC)──> [P1 / P2 / P3] │ (Short Press SET) │ ▼ [Configure Parameters] Parameter Code breakdown Parameter Name Factory Default Adjusting Range Functional Description Operating Mode U, P, C, D

Ensure that the value you program for the lower limit () is always lower than the upper limit ( P2 ).

Users should supplement the manual with online forum posts or a multimeter check. Xh-m608 Manual

This is the voltage at which the charger starts charging (or the load reconnects).

*Source: *

High loads over 10A can destroy the relay. Here is a practical guide to understanding and

The (also known as HCW-M631) is a versatile DC 6-40V battery charge/discharge module featuring high-precision voltage monitoring and programmable protection thresholds. Key Specifications Input Voltage Range: DC 6-40V. Voltage Accuracy: ±0.1V.

Programming the XH-M608 involves selecting the mode and setting the target voltages. Factory Reset

Route the positive charging wire from your power supply to the relay terminal. Users should supplement the manual with online forum

Behavior: The module allows the load to run continuously until the battery voltage falls to your low cutoff limit, instantly breaking the circuit to isolate and save the cells. The Master Function Matrix (P0 – P3 Settings)

A: The relay contacts are rated at 10A at 30VDC or 10A at 250VAC. For higher currents, use the relay to control a larger external contactor.

Press SET while on a parameter to view its current value, then use ADD/DEC to change it. Long-press ADD/DEC for rapid adjustment. Range / Modes P0 Working Mode U