Wittmann Tempro Plus D 360 Manual !!top!! Jun 2026

A: The unit is designed for a maximum operating temperature of 360°F (182°C).

Check that the cooling water drain line is completely open. Verify the cooling solenoid opens when signaled. Reset the manual safety thermostat if it tripped prematurely. Error: No Flow / Low Flow Rate

High-volume pumps equipped with magnetic couplings to eliminate leakage.

Connect the main supply lines to the cooling water inlet and outlet. Ensure the return line has minimal backpressure. Wittmann Tempro Plus D 360 Manual

You should start by visiting the official Wittmann Group website. Navigate to the "Temperature Controllers" section and locate the "Tempro plus D360" product page. Look for a tab or section, where manuals and datasheets are typically available in PDF format. The product page is a primary resource where the manufacturer provides the latest documentation directly to users. Searching for the “Wittmann Tempro Plus D 360 manual PDF” on a search engine may also lead you to results from industrial auctions, parts suppliers, and technical documentation sites. However, always ensure that any manual you find online is for the correct model (D360) and, ideally, matches your unit's serial number and options, as configurations can vary.

A mold symbol on the screen changes color based on temperature status: Green (within tolerance), Red (too hot), and Blue (too cold).

Connect the cooling water input and output, and connect the mold to the unit's supply and return lines. Power On: Ensure the main power supply matches the unit requirements. Filling the System: The Tempro Plus D 360 A: The unit is designed for a maximum

features automatic filling. Switch on the pump to start the filling process. Ensure the air is fully bled from the mold circuit.

The Tempro Plus D series stands out due to its ability to handle high temperatures using water as a medium, often providing a cleaner and more efficient alternative to oil-based systems. The "D" denotes the advanced "D" control system, featuring a color screen for enhanced monitoring and user interaction. Operating Temperature: Up to or higher, depending on the exact variant.

Monitored via internal electronic transducers to ensure the system remains pressurized above the steam curve. Changing the Temperature Target Tap the Temperature Setpoint box on the home screen. Input the desired numerical value via the pop-up keypad. Reset the manual safety thermostat if it tripped prematurely

Clean the factory water inlet filter. Verify that factory cooling water valves are open. Check contactor mechanical operation. Low Flow / No Flow Alarm

This manual is a representative technical guide. Always refer to the official Wittmann documentation accompanying your specific unit. Firmware version R8.2.3 or higher required for all described features. Last revision: September 2024.

Note: Always refer to your specific, official documentation from the Wittmann manual site for safety warnings. Initial Start-up

Flush the internal circuit with an approved chemical descaling agent.