invt che100-0r7g-s2 manual » invt che100-0r7g-s2 manual

Invt Che100-0r7g-s2 Manual

: The grounding terminal (PE) must be connected to earth ground securely. Do not skip this step. 3. Wiring Diagram and Terminal Functions

Q: Where can I download the INVT CHE100-0R7G-S2 manual? A: You can download the INVT CHE100-0R7G-S2 manual from the INVT website or authorized distributors.

: Increase or decrease parameter codes and numerical values.

Internal DC bus voltage exceeds critical thresholds. Commonly happens when heavy inertial loads force the motor to act as a generator during rapid deceleration. invt che100-0r7g-s2 manual

Set P0.13 to 1 to restore factory default settings.

: Application Type. "G" stands for Constant Torque (General Load). S2 : Input Voltage Class. "S2" indicates single-phase AC input ( Main Specifications Input Voltage : Single-phase AC Output Voltage : Three-phase to Input Voltage ( Output Current : Rated at approximately continuous. Output Frequency Range :

Cause : Continuous heavy load; motor is stalled; incorrect motor rated current settings. : The grounding terminal (PE) must be connected

If the drive trips, the keypad will display an error code. Here are the most common ones found in the CHE100 manual:

Before diving into the manual, let’s decode the model number, as the manual refers to these specifications constantly:

: Voltage class and phase. "S2" indicates a Single-Phase 220V AC input ( 2. Technical Specifications Specification Details Input Voltage Single-Phase 220V AC, 50Hz/60Hz (Range: 187V–264V) Output Voltage Three-Phase 0V to Input Voltage, 0Hz–400Hz Rated Output Current 4.5 Amperes (A) Applicable Motor 0.75 kW (1 HP) 3-phase induction motor Control Mode Sensorless Vector Control (SVC), V/F Control Overload Capacity 150% of rated current for 60 seconds; 180% for 10 seconds Cooling Method Forced air cooling with built-in DC fan Enclosure Rating IP20 (Must be mounted in a clean, dust-free enclosure) 3. Installation and Environmental Requirements Wiring Diagram and Terminal Functions Q: Where can

Cause : Acceleration or deceleration is too fast; motor short circuit; ground fault.

The output of the CHE100-0R7G-S2 is three-phase 220V . It is designed to control a three-phase induction motor, not a single-phase motor. Attempting to run a single-phase motor without derating will damage the drive.

Analog Input 1. Receives 0–10V DC or 4–20mA current loops for external speed references. COM: Digital and analog common reference point.

Leave a minimum of 150mm clearance above and below the drive, and 50mm on each side.