For long distances (>30 ft), lean the device against a stable surface or use a mini tripod mount (not included) to eliminate hand shake.
Located on the rear or bottom casing, housing the power cells (typically 9V or AAA batteries depending on production batch). Technical Specifications Specification Model Point-N-Measure W5746 Measurement Range 2 feet to 50 feet (0.6 meters to 15 meters) Accuracy +/- 0.5% of the measured distance Power Source 1 x 9V Alkaline Battery (or specified equivalent) Operating Temperature 32°F to 104°F (0°C to 40°C) Laser Class Class II Laser Product (where applicable for targeting) Automatic Shut-off 30 to 60 seconds of inactivity Getting Started Initial Setup and Battery Installation
Allow the device to warm up or cool down to room temperature. Point-N-Measure Digital Tape W5746 User Manual
To help you get the most out of your device, please share a few details about what you are currently working on: Are you getting a specific on the display?
This requires the unit to be level. Slight tilting will skew results. For long distances (>30 ft), lean the device
What specific (Area, Volume, Continuous) are you trying to use?
If the display is dim or shows a low battery icon (a blinking battery symbol), replace the 9V battery immediately for consistent accuracy. To help you get the most out of
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Use the button to increase or decrease the calibration value by millimeter increments (up to ±7mm). Press MEAS to save the calibration setting. Troubleshooting Error Codes
Are you trying to the device for an upcoming project? Share public link