Leica Tcr805 Total Station User Manual ✓

Whether you are using the TCR805 for topographic surveys, setting out construction points, or monitoring deformation, understanding its operation through the official user manual is essential for maximizing accuracy and efficiency. 1. Introduction to the Leica TCR805 Manual

Flip the telescope and rotate the instrument to sight the exact same target in Face 2 (Telescope inverted).

Look at the ground mark and adjust the tripod legs until the laser dot sits precisely in the center of your ground nail or monument.

This guide provides a comprehensive overview of the (TPS800 series), designed to help surveyors, engineers, and construction professionals master this versatile surveying instrument. leica tcr805 total station user manual

: Switches between different display masks and menu tabs. Main Menu Structure

For land surveyors, civil engineers, and construction professionals, the represents a pivotal piece of heritage technology. Known for its robust build, accurate EDM (Electronic Distance Measurement), and onboard software, the TCR805 was a workhorse of the early 2000s. However, two decades later, one of the biggest challenges owners face is locating and interpreting the original Leica TCR805 Total Station user manual .

Notes, assumptions, and final remarks

Before taking measurements, you must tell the total station where it is located in coordinate space ( Press , select Station Setup , and press Enter. Input the Station Name, Instrument Height ( ), and known coordinates.

Instrument is severely out of level or wind is shaking the tripod.

Accurate data begins with a flawless physical setup. Follow these steps to eliminate center and leveling errors. Step 1: Tripod Setup Extend the tripod legs to a comfortable working height. Whether you are using the TCR805 for topographic

Aim precisely at a highly visible target roughly 100 meters away. Measure the point in Face 1 (telescope normal).

: Up to 3,500 meters using a standard Leica round prism

Select . Enter the Station ID, Instrument Height ( ), and coordinates ( ). If coordinates are unknown, use local assumptions ( Look at the ground mark and adjust the

Match the baud rate, parity, and data bits between your PC software and the TCR805 settings ( -> Config -> Comm ). Standard settings are usually 19200 Baud, 8 Data Bits, No Parity.